Did it fix the problem or cause the machine to boot faster? If not, then try editing the copy again. Now reboot your machine, but when in Clover go to Options -> Configs, and select the copy that you just finished editing, and continue booting. Open it by double-clicking the file and launch Clover Configurator for a graphical environment or right-click the file, select "Open with.", then select TextEdit to use the text editor to edit the file. Now you can either "config ist" to distinguish it from the primary. I prefer to keep filenames without spaces, but you should be able to leave yours as-is without problems. If you're using a standard Windows keyboard and haven't yet mapped the correct keys, use the Windows key between the Ctrl and Alt keys along with C to copy and V to paste. The steps to remap the keys explained earlier. Note: On an Apple keyboard the keys directly on the sides of the spacebar are Command keys, but on a Windows keyboard these are Alt keys. Basically as long as the entry starts with "config" then it should be visible when you select other configurations. If you do something similar you can still give descriptive names such as "config_ist", "config_1.plist", "ist" (previous example minus the underscore), and more. My solution was to rename the extra entries so that they started with "config" before the ".plist" extension, and that fixed it. I had to hook up the flash drive to another machine to confirm those extra entries were still there, which they were. But I noticed that when I would boot my machine and get into Clover, I would go to Options, go to Configurations", and the only entry in the list would be the "ist" file. I eagerly copied these to my EFI/CLOVER folder so that I would have an assortment to test out. When getting pre-built configurations for my AMD system, each configuration was named by the processor or board type, such as "ist" or "ist".
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |